8923 High performance polyurethane adhesive sealant for bus air conditioning , weld

8923 high performance polyurethane sealant for Seal bus air conditioning, weld, luggage and other parts8923 high performance polyurethane sealant is a single component, W High thixotropy, does not flow, low odor polyurethane adhesive. Product is low viscosity, good thixotropy, which is convenient for manual gluing. Cured adhesive is elastomers, anti cold and hot change, good resistance to stress change performance. Can be painted, polished, no corrosion, elevation and top construction does not flow. There is extensive adhesion to various substrates.Typical useSeal bus air conditioning, weld, luggage and other parts. Deal ships, locomotives, construction, paint and other industries and other usage of low bond strength.Characteristic before curingRepresentative value rangeA componentColor White/greyDensity g/cm3(25℃) 1.30 1.25～1.35(GB/T13354-1992)Touch Curing(min) 50 40～60(23℃/50%RH)(GB/T13477.5-20)Characteristic after curingTensile strength MPa 2.5 2.3～2.8(GB/T528-1998)Elongation at break (%) 500 450 ～700(GB/T528-1998)Tear strength KN/m 11 ≥9(GB/T 529)Harness: Shore-D(GB/T 531-1999) 55 50～60Work Temperature℃ -40～90Instructions for useSurface cleaning:clean surface: remove the rust, dirt, water and oil etc…Gluing:cut a small hole in the beak suitable rubber barrel, glue mouth diameter should be considered sizing width and decide, into the glue gun start sizing operation.Curing:a large temperature and humidity environment on polyurethane adhesive surface drying and curing effect, low temperature, curing slow; temperature and humidity is too high, dry too fast. The best operating environmental conditions: temperature 20 to 30 DEG C for 50 ~ 70%RH, humidity exceeds 5 to 35 DEG C; the temperature, humidity 35 ~ 75%RH range please careful construction.Polyurethane adhesive in gluing and curing process, avoid contact with chemicals containing hydroxyl, amino and, this kind of material will cause the polyurethane glue curing incomplete.Storage:unused plastic blocks should be tightened immediately, to seal the tube mouth save. Again, if sealed, a little crust, remove immediately after, does not affect the normal use. In the process of storage, the nozzle may also appear a few crusts, remove after normal use, does not affect the product performance.The matters needing attentionKeep away from children.If you accidentally come in contact with the skin, wipe in the curing a cloth before class, and using alcohol solvent scrubbing.If the case of contact with eyes, rinse immediately with water, and medical treatment.Recommended for use in a well ventilated placeProduct safety data please refer to the product MSDS.Package310ml/Tube,24tube/Carton600ml/Soft tube 20tube/CartonStorageStore in cool and dry place 5-25 C (humidity less than 70% RH)Storage period: Hard pack for 9 monthsSoft pack for 6 months