7603 Retaining Anaerobict Cyanoacrylate Adhesives low viscosity, high strength, good oil tolerance, and excellent medium

Huitian®7603 retaining compoundis a one-component retaining compound for retaining cylindrical parts, which features low viscosity, high strength, good oil tolerance, and excellent medium resistance. It is used between two closely fitting metal surfaces, and cures when isolated from air.Typical ApplicationsRetaining of radial clearance of less than 0.1mm between metal transition or interference fit holes and shafts. This product can be used on surfaces with slight oil stains and can achieve maximum strength at room temperature. It can also serve as a sealant and is easy to use.Properties before CuringTypical value                    RangeAppearance                       Green liquidChemical composition       MethacrylateViscosity (mPa.s)(GB/T2794-1995)Brookfield RVT2# rotor 20 rpm                                                        100~200Density (g/cm3)                         1.10                       1.00~1.15(GB/T13354-1992)Flash point (℃)                                                           >93(SH/T0733-2004)Maximum filling gap (mm)         0.10Initial curing time (min)                                               ≤30Properties after CuringFull curing time at RT (h)            24Static shear strength (MPa)        28                       20~35(GB/T18747.2)Working temperature (℃)                                    -50~150Chemical/solvent resistanceAged under the following conditions and tested at 22°CSolvent Temperature (℃) Initial strength residual rate (%)100h500h1,000hEngine oil125100100100Leaded gasoline251009085Brake fluid251009080Ethanol25100100100Acetone25909090Water/glycol (50%/50%)871009080Directions for UseClean the hole-shaft fitting surface, remove oil and dirt, and allow to dry. It is recommended to use Huitian 7755 cleaner to improve the cleaning effect. Apply the glue evenly to the fitting part, with the amount of glue enough to fill the gap, and assemble to the appropriate position according to the specification requirements. The sealing effect is best when the gap is small, and the curing speed will be affected by larger gaps. For larger gaps, it is recommended to use the Huitian 7769 accelerator to improve the sealing effect. In order to ensure the maximum pressure resistance of the system and the best medium resistance of the adhesive layer, the curing time is recommended to be more than 24h to ensure full curing of the adhesive layer.CautionsThe unused glue should be sealed and stored for reuse. The contaminated glue should not be returned to the original package bottle; otherwise, the performance of the remaining glue in it will be affected.The product is not suitable for plastic parts, pure oxygen, or oxygen-enriched systems, and cannot be used to seal chlorine or other strong oxidizing substances.Keep away from children for storage.The product contains acrylic and methacrylate substances and irritates the skin and eyes. It is recommended to use the product in a well-ventilated place.If eyes or skin is accidentally exposed to the product, rinse immediately with water.Please consult the MSDS of the product for safety information.Packing specificationOrder code:760301, 50 ml/bottle, 10 bottles/box, 80 bottles/carton760303, 250 ml/bottle, 10 bottles/boxStorageStore at 8~28°C in a cool and dry place.Shelf life is 18 months.